Power
3-wire AC line input (117V, 60 Hz typical) with power-on indicator. Both Models are available in 220-240VAC@50Hz
Variable DC output
-1.3V to -15V @ 0.5A, ripple <5mV
Frequency Range
0.1 Hz to 100 kHz in six ranges
Output voltage
0 to ±10V (20Vp-p)
Output Impedance
600 ohms (except TTL)
Output current
10mA maximum, short circuit protected
Output waveforms
sine, square, triangle, TTL
Sine wave
distortion <3% (10Hz to 100kHz)
TTL pulse
rise and fall time <25 nS. drive to 10 TTL loads
Square wave
distortion <3% (10Hz to 100kHz)
Logic Indicators
8 LED's, active high, 1.4 volt (nominal) threshold, inputs protected to ±20 volts
Debounced Push-Button (Pulsers)
Two pushbutton-operated, open-collector output pulsers, each with one normally-open, one normally closed output. Each output can sink up to 250 mA
Potentiometers
One 1 K ohm, one 10 K ohm, all leads available and uncommitted.
BNC Connectors
Two BNC connectors, pin available and uncommitted, shell connected to ground.
Switches
Two SPDT slide switches, all leads available and uncommitted. 8-pole DIP switch: one side of all eight switches connected and switchable to +5V or ground, other side of all eight switches separate, available, and uncommitted.
Breadboarding Area
Three UBS-100 sockets with 840 tie-points each for a total of 2520 uncommitted tie-points. Two QT-59B Bus strips internally connected to power and ground. Fifty tie-points each for +5V, +V,=15 V and ground.
Enclosure
High impact molded case.
Overall Dimensions
6.5in H x 16 W x 11.5in D
