Transforming Technologies CM420 Impedance Monitor, 2 Operators + 1 Mat

Home > SHOP ALL PRODUCTS > Brands > Transforming Technologies >

Our Price: $254.07

Availability: Usually Ships in 1 to 2 Weeks
Product Code: CM420

Description

Datasheet PDF format

Features

Two Operator & Mat Constant Monitor
Continuously verifying the integrity of the ground system is critical to an effective ESD protection program. The CM420, single wire monitoring products continuously check the total ground loop, including the operator, the wrist band, the coil cord and the worksurface. The systems are compatible with most single wire wrist straps. This is an entry level monitor, and will ensure a wrist strap is continually working and the worksurface is grounded. A audible alarm and light will signal a failure.

Features:

Checks two wrist strap/person and bench.
Compatible with any standard wrist strap.
Easy to use: Simply plug in the wrist strap and connect to bench ground.
Easy to install: Attach the monitor to the bench with included hardware and bracket, and plug it in.

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

SHOP ALL PRODUCTS > Brands > Transforming Technologies
SHOP ALL PRODUCTS > ESD Products
SHOP ALL PRODUCTS > ESD Products > Monitors
SHOP ALL PRODUCTS > Brands
SHOP ALL PRODUCTS

	Keithley 2510 TEC SourceMeter, 50W (5A, 10V), P-I-D Controller $9,230.80 USD
	Keithley 3765 HALL EFFECT CARD $16,638.00 USD
	Rigol DSG821 RF Signal Source from 9kHz-2.1GHz $2,299.00
	Rigol DP831 Power Supply with +30 and -30V @ 2A channels, an 8V/5A channel, 10 mV/10 mA measurement resolution $473.00
	Rigol DS2102A 100 MHz, 2 Channel Oscilloscope with 2 GSa/sec and 14 million memory points standard as well as low noise front end (500 uV/div) and 65,000 frames of waveform recording all with a vibrant 8 inch display. 50 Ohm input included. $569.00